qmk_firmware/keyboards/psuieee/pluto12
James Young c4e182b98e
Migrate `LOCKING_*_ENABLE` to Data-Driven: P, Part 2 (#23780)
Affects:

  - `preonic/rev1`
  - `preonic/rev2`
  - `preonic/rev3`
  - `preonic/rev3_drop`
  - `primekb/meridian/ktr1010`
  - `primekb/meridian/ws2812`
  - `primekb/meridian_rgb`
  - `primekb/prime_m`
  - `primekb/prime_o`
  - `primekb/prime_r`
  - `projectcain/relic`
  - `projectcain/vault45`
  - `projectd/65/projectd_65_ansi`
  - `projectd/75/ansi`
  - `projectkb/alice/rev1`
  - `projectkb/alice/rev2`
  - `projectkb/signature65`
  - `projectkb/signature87`
  - `prototypist/allison`
  - `prototypist/allison_numpad`
  - `prototypist/j01`
  - `psuieee/pluto12`
  - `pteron36`
  - `puck`
  - `punk75`
2024-05-23 19:49:53 +01:00
..
keymaps/default Delete trivial keymap readmes (#23714) 2024-05-17 23:49:29 +01:00
keyboard.json Migrate `LOCKING_*_ENABLE` to Data-Driven: P, Part 2 (#23780) 2024-05-23 19:49:53 +01:00
readme.md

readme.md

pluto12

pluto12

The pluto12 is a 4x3 macropad designed for use in the Penn State IEEE Student Chapter's 2021-22 workshop series. Designed by the 2021-22 Penn State IEEE Projects Committee.

Make example for this keyboard (after setting up your build environment):

make psuieee/pluto12:default

Flashing example for this keyboard:

make psuieee/pluto12:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available